EA734291

[X60 Ultra] Dreame L50 Ultra is a nightmare! Don't buy it.

I have the L50 Ultra and it is terrible!  It doesn't clean under the edges of cabinets, gathers up cat hair and leaves it in wads all over the house, and doesn't pick up small plant leaves and debris on the floor.   My old $200 Wyze robovac worked better!!!  Dreame is an overhyped, overpriced piece of junk.  Highly DO NOT recommend this!!  
You need to log in to reply. Login | Register

12 Comment

Sackleh 1 Floor
I have the x50 ultra and I feel the same way.  I paid way more for the brush and mop extend features so it can get the corners under my cabinets.  It doesn’t even turn itself at a right angle like the cabinets and goes in at 44 degrees missing more space than my six year old iRobot wouldn’t miss! It also leaves a lot of dirt behind!
2026-5-10 22:55:02 US Translate

You will need to adjust the type of cleaning . Intensive or deep clean..this slows the pass  time & area cleaning. I would remap it & start over with these deeper cleaning settings.
2026-5-24 10:02 US Translate
HQ275695 2 Floor
Mine worked great for a few weeks. Then it just completely stopped adhering to the schedule and wouldn’t vacuum at all. Finally started working again and mop pads would either keep falling off or it would just say the mop pad fell off when it didn’t. So I stopped using the mopping function. Did its job vacuuming after that…for one night. Now it keeps finding thresholds when there are none and stopping in the middle of the floor saying it’s obstructed and to put it in an open area. Absolute trash device.

Last edited by HQ275695 on 2026-5-21 10:38
2026-5-21 10:37:38 US Translate

Stopped using it for two months but figured there had to be something I could do to fix it. I thoroughly cleaned it and ran it again. It worked again for one night. The second night it got stuck on the carpet under my coffee table, which I have set to avoid. I stopped it and reran it and it literally went straight back to that carpet. I got frustrated and stopped it and sent it back to dock, but now it can’t dock at all. It keeps trying and trying but is unable to dock. What an absolute abomination of a product. Was this thing tested at all? I don’t even have a difficult floor plan. It’s one floor, all the same material, less than 1,000 square feet. I could probably make a better damn vacuum myself.
2026-8-2 10:02 US Translate
Same on mine. Total garbage.
2026-5-24 00:18 US Translate
UU504230 3 Floor
Agree it doesn’t clean good around and under cabinet legs!
2026-5-23 14:26:48 US Translate

JDoak 4 Floor
I agree. This thing is garbage. My Roomba 960 was way better workhorse than this hunk of junk.
2026-5-24 00:18:04 US Translate

WQ363752 5 Floor
If you can’t figure out the settings then you’re just an idiot. It’s more likely that you’re a competitor fudding around
2026-5-24 08:36:41 US Translate

That's not very nice. maybe you shouldn't be on a forum where people are learning to operate something new.
2026-5-24 10:39 US Translate
DeGraaf86 6 Floor
I was surprised by it lack of suction and inability to get under cabinets but once I changed the suction power and settings for it to get under low clearance items as well as turn on the extended reach setting it has been doing great. My biggest issue is it change its map sequence so now it jumps around from room to room instead of going in sequential order but it still gets everything in the end.
2026-5-24 08:48:58 US Translate

Did you increase suction setting? You have to set things to your cleaning needs... intensive deep cleaning setting work beautifully...
2026-5-24 10:38 US Translate
IG648929 7 Floor
I would factory reset. Map it again.
2026-5-24 10:01:00 US Translate

UID:EA734291 US
  • 1Posts
  • 0Friends

© 2026 Dreame Forum All Rights Reserved | Support by Discuz! X5.0 Font by MiSans

Quick Reply Back to Top Return to List