L10 ultra robot

Doesn’t finish task. Keeps saying main brush wrapped

Clean the brush?

Doesn't helped. Even changed brush.  Just removed it. Was too annoyed by this

I am having the same issue.  There is nothing on or around the spin brush but it will constantly stop.

I think the flaps on the main brush body start to slide off. I have had to push them back into place at the root of the body.

I'm having the exact same problem with my L20 Ultra, main brush is wrapped, even does it without the brush installed. Was there a recent firmware update that's screwed something up?

Only owned the aqua 10 for a few hours and the main brush wrapped error hasn’t stopped. I’m about to return this thing.

What is the final fix for this?