X40 not wetting

I feel like my ultra x40 is wetting the mop pads enough all of a sudden. Any idea why?

Hi,

We apologize for any inconvenience this may have caused.

Please try resolving the issue by following the steps below:

1. **Test Without Mop Pads**:

- After washing the mop pads, remove them from the mop pad holder. Install just the mop pad holder into the robot.

- Start a mopping task from the base station and wait for 5 minutes.

- Check if there are any water droplets on the ground.

2. **Unclog Water Outlets**:

- If no water flows out in the test above, remove the mop pad holder.

- Use an iron wire, toothpick, or similar item to poke the water outlets at the bottom of the robot.

- Check if this resolves the mopping issue.

If the problem persists, please feel free to contact us(support.na@dreame.tech) again.

Thank you for your understanding.