Not cleaning along the baseboard

Hello,
L40 ultra is not cleaning along the baseboard. It gets on and off of it. I gave it a try for a couple of times but no change in behavior. Please see the attached for settings and path it followed during cleaning and missed areas with red circles.

Hi,

Please refer to the troubleshooting below：

1.  Wipe the edge sensor on the right side of the robot with a soft, dry cloth.
2.  Ensure the edge sensor is not blocked by any obstacles or objects.
3.  Check that the robot can properly clean the edges.
4.  If the problem persists, please feel free to contact support.na@dreame.tech again.

We hope the above information is helpful to you.